Suggestions for Disassembling a Balisong Trainer

 Using the incorrect driver size is the simplest method to utterly damage your balisong trainer. The majority of balisong use torx-based pivots, and utilising inferior or incorrectly sized torx drivers can easily end up in stripping pivots or hardware. The benchmark is regarded as WHA brand drivers. You can utilise this spreadsheet to

Figure out what tools your balisong has.

How to handle Blue or Red Loctite
Find whether your balisong trainer has been located and what type, if so. Usually, you may find it by executing a little research or just by asking around. The majority of manufacturers will ship their balisongs with blue loctite, which should be easily removed with a small amount of tension.

Your balisong might have been red loved if you bought it off the secondary market. You would need to utilise heat to sever the link when you have balisong that has been infected with Red. Some individuals select to heat up the balisong, while others utilise a lighter or soldering iron to repair the components or pivots.

Of course, you can’t solder or use an open flame on balisongs made of G10 or other non-flammable materials. There are typically two ways to fix the problem if your pivots or components rotate when you move the male part of the pivot. In an effort to prevent the pivots from effortlessly rotating, you may forcefully squeeze the handles against the tang or zen pins to put little pressure on the blades.

You can place a rubber pad similar to the kind used to open jars on the floor and then press the pivots into the rubber to grab the female part of the pivot while turning the male screws.

The first attempt involves using a large Torx driver. Through getting some how large torx driver, the next big sizer one, and trying to push it into the stripped pivot screw, you may be able to extract a little stripped screw occasionally. When rotating the screw, ensure to offer robust Coward pressure.

Super Glueing the Torx driver to the screw is what you may do as next attempt. Based on the glue, you might have to sacrifice the driver, but it’s likely that you can separate the screw from the driver upon removing it with a little intense heat. To avoid making matters worse and glueing the pivot into the handle slabs, be careful not to get any adhesive outside of the pivot.

Utilise a drill press or a vice to grasp the handle firmly. You may be able to put through the screw rather quickly with an has, titanium, or other metal drilling bit. Take exceptional care thereby to avoid damaging the handle itself.